Semi-automatic Plateau Milling Machine

The complete system is controlled by a dedicated PLC System with Touch Screen Display.


The milling path is controlled by inbuilt Lasers and the milling cutter follows the various Laser guided locations.


Power is derived from 230V AC / 110V AC and Air at 95 PSI. Battery Backup is included and the system will run for three hours without electrical input on its internal battery.


Cutting speed is 15,000 RPM with a feed of 2000mm/min.

The example above is for a

Pylon Milling Machine

Typical Headstock Installation

Z Depth control is manual and measured with a Digital Read Out.


The resolution is 0.01mm.


About Us



Contact Us

© Grange Square Ltd 2016 All Rights Reserved